Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)
Tire shredder is a new type of high efficiency rubber tire crushing equipment. The waste tire recycling machine has low price, small size, simple structure, large crushing ratio, large production capacity, uniform product particle size, and selective crushing effect. These obvious advantages make the tire recycling machine show a decisive role in all walks of life, but its large dust defects also trouble many manufacturers and users of tire recycling machine equipment. Here, Zhengzhou Yuxi analyzes the reasons for the large dust of the red shredder?
First, the material is crushed in a multi-stage high-speed blow in the tire shredder cavity. The particle size of the material will be finer and finer, and then driven by the rotor, it will continuously fly out due to its own inertia. After a long-term operation of the equipment, the casing and hammer are subject to a certain amount of wear, which results in the equipment's tightness, and a large number of fine particles fly out; the exhaust dust removal system of the discharge mechanism has insufficient dust treatment capacity, which leads The amount of dust leakage at the material end is large, causing a certain degree of dust.
Tire shredder dust removal equipment is roughly divided into two categories: pulse bag dust collector and round pressure dust collector. The tire recycling machine dust collector is composed of five parts: upper, middle and lower cabinets, dust removal device and spray dust cleaning system. The upper box is provided with a blowing pipe and an air outlet. The middle box is composed of a perforated plate, a venturi tube, a filter bag, a keel, a pulse valve, and an air bag ash cleaning system. The lower box has an ash bucket, an air inlet, an inspection door, and an ash discharge device consisting of a rotary ash discharge valve or a screw conveyor.
The tire recycling machine equipment further improves efficiency and performance. We broke the shackles of traditional single-rotor crushing and designed two sets of series-type rotors to achieve the purpose of upper and lower crushing. The secondary crushing of the material that is not crushed by the upper hammer head, plus the impact of the reverse impact of the inner cavity material, makes the material more completely crushed, so there is no dead corner crushing, and the hammer head is fragile. As the wear between the hammer head and the lining continues, the lining can also be adjusted from the outside to the inside to control the size of the feed.